MediaMatrix nTouch 180 Instrukcja Obsługi Pobierz pdf (Strona 56)

Chapter 6 - Maintaining the nTouch 180 unit

52 Version 1.7.2.0 March 27, 2015

<get_switch>

</get_switch>

<wipe_switch>

</wipe_switch>

</Control>

</RecoverySwitches>

Each of the switches is explained in the table below.

exit_switch

When set to 1, shuts the computer down after the recovery

process has finished. Default is 1.

put_switch

When set to 1, restores the system from the .7z image file,

located in the MM_Config folder on the USB stick. Default is 1.

get_switch

When set to 1, retrieves the system image from the nTouch 180

unit, places it in a .7z file, then copies the file to the MM_Config

folder on the USB stick. Default is 0.

wipe_switch

When set to 1, reformats and repartitions the hard disk, wiping

the contents from both C: drive and D: drive on an nControl

unit.

When set to 0, C: drive will be formatted and the system will be

restored on this drive; the contents of D: drive will be left intact.

Default is 0.

Note: This switch is for nControl units only. The contents of D:

drive on nTouch 180 units are always lost as part of the

recovery process.

The switches are set to 1,1,0,0, by default. This will restore the system without wiping the D:

drive, then will shut down the nTouch 180 unit.

Specifying 0,0,0,0 will simply boot the system and display a command prompt.

1 2 ... 51 52 53 54 55 56 57 58

Brak uwag

MediaMatrix nTouch 180 Instrukcja Obsługi Strona 56