MediaMatrix nTouch 180 Instrukcja Obsługi Pobierz pdf (Strona 27)

nTouch 180 Hardware Manual

March 27, 2015 Version 1.7.2.0 23

Using the touch screen interface

Switching the unit on and specifying the basic network settings

The nTouch 180 unit is configured to connect to a DHCP server to obtain an IP address and

network settings. If it cannot find a DHCP server, an IP address starting with 169 will be used.

The current network settings are displayed at the top of the main set up screen.

If you want to use DHCP, you do not need to change the network set up, but it is important that

you check that the network to which you are connecting the unit has a DHCP server.

Note: If DHCP mode is selected, but there is no DHCP server on the network, the unit will be

unable to communicate with other devices.

 To switch the unit on and specify the basic network settings

1. Power up the unit.

The unit will start up as soon as it receives power.

2. Check that the green power LED is lit on the front of the unit above the display. If it is not,

check that the power cable is connected to the unit and the power is switched on.

The unit will start up automatically. This screen is displayed during the boot process.

If the nTouch 180 has been configured with a username for connecting to Kiosk:

The Starting Kiosk countdown screen is displayed.

 Press Run Setup to display the main set up screen.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 57 58

Brak uwag

MediaMatrix nTouch 180 Instrukcja Obsługi Strona 27